Technical Information, Motorcycle Tips and FAQs
Mini Beast Air horn - installation questions, FAQs and helpful tips Frequently Asked Questions
Q. How loud is it?
A. Click here to view the video and find out. http://www.youtube.com/watch?v=8xFepbfXEBs
Q. How long should the installation take me?
A: About 20-30 minutes depending upon which HD you have.
Q. Do I need to remove the gas tank?
A. Absolutely not, the small hot wire will right up against the bottom of the tank but you should not have to take the tank off to make it look clean. Zip tye the hot wire to the horn bracket, then run it under the tank and zip tye again where the wire comes out from under the tank against the frame. This will hold the wire in place and out of sight.
Q. Do I need a separate wiring kit or relay?
A. No, all the wiring you need for a perfect install is already in place underneath the cover, including a heavy duty, sealed relay along with heat-shrink connectors and heat shrink tubing.
Q. The Mini Beast seems heavy for this rubber bracket, is that a problem?
A. No, the extra weight helps offset the vibration causing the horn to shake less therefore putting less stress on the rubber mounting mechanism. Also, we have 1000s of miles on these brackets and they have proven their durability.
Q. How loud is it?
A. Click here to view the video and find out. http://www.youtube.com/watch?v=8xFepbfXEBs
Q. How long should the installation take me?
A: About 20-30 minutes depending upon which HD you have.
Q. Do I need to remove the gas tank?
A. Absolutely not, the small hot wire will right up against the bottom of the tank but you should not have to take the tank off to make it look clean. Zip tye the hot wire to the horn bracket, then run it under the tank and zip tye again where the wire comes out from under the tank against the frame. This will hold the wire in place and out of sight.
Q. Do I need a separate wiring kit or relay?
A. No, all the wiring you need for a perfect install is already in place underneath the cover, including a heavy duty, sealed relay along with heat-shrink connectors and heat shrink tubing.
Q. The Mini Beast seems heavy for this rubber bracket, is that a problem?
A. No, the extra weight helps offset the vibration causing the horn to shake less therefore putting less stress on the rubber mounting mechanism. Also, we have 1000s of miles on these brackets and they have proven their durability.
Pro Pad - installation questions, FAQs and helpful tips Frequently Asked Questions
Q. How do I install my Pro Pad?
A.Installation is easy with our two-part system: (1) a sewn-in elastic strap towards the front of the pad that can be flossed between a two-part seat like those found on Fatboys, (2) a strapping system at the rear sides of the pad with detachable clips, adjustable elastic straps and coated metal hooks. These hooks can then be attached to the bottom edge of the seat, to each other underneath the seat, to a rail or the hooks can be removed and the elastic can be looped around a bar.
